Who wants to be a spar manufacturer?!

General conversation and discussion about the IKE Club.
User avatar
Jeff
Posts: 1767
Joined: Wed, Nov 22 2006, 09:03 AM
Location: Lakewood, CO

Who wants to be a spar manufacturer?!

Postby Jeff » Wed, Oct 02 2013, 03:16 PM

Keep calm, and park it in the pocket

IKE is on Image too!

User avatar
makatakam
Posts: 574
Joined: Wed, Jun 29 2011, 11:48 PM
Location: Schaumburg, Il

Re: Who wants to be a spar manufacturer?!

Postby makatakam » Thu, Oct 03 2013, 08:09 PM

ONLY! one inch diameter? I was hoping for something in the 2" to 3" range.
MARK

"...it's a fair wind blowin' warm, out of the south over my shoulder, guess I'll set a course and go." CSN&Y

User avatar
goestoeleven
Posts: 2317
Joined: Sun, Sep 12 2010, 09:07 PM
Location: Wheaton, IL

Re: Who wants to be a spar manufacturer?!

Postby goestoeleven » Thu, Oct 03 2013, 08:50 PM

Oh, I'm sure those tubes are just as strong and light, and would fly just as well . . . . not!


Return to “Club Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest