Page 1 of 1

Need some help if possible.

Posted: Wed, Sep 12 2012, 11:54 AM
by Darkspark
Hey guys and gals, I have a request to make a couple sets of handles from someone, and they want the curve profile to match the indoor handles. Could someone who has a set of indoor handles take a photo of them for me? Maybe next to a regular handle and a ruler or measuring tape for scale? I will be forever indebted to you!
:thanks: In advance to all the takers!

Re: Need some help if possible.

Posted: Wed, Sep 12 2012, 04:04 PM
by goestoeleven
You might want to PM Dayton David - I know he has an Indoor, because . . . . I attempted to fly it at the hotel at KOLM on Sunday night.

Re: Need some help if possible.

Posted: Wed, Sep 12 2012, 08:15 PM
by Mike
Big Mike also has an indoor. You could drop by his house...

Re: Need some help if possible.

Posted: Wed, Sep 12 2012, 09:30 PM
by makatakam
indoor-hndls-175[1].jpg
indoor-hndls-175[1].jpg (1.8 KiB) Viewed 1766 times


Or, you can just use this.

Re: Need some help if possible.

Posted: Thu, Sep 13 2012, 10:56 AM
by Darkspark
I may go knock down Big Mikes door. If nothing else just to say Hi. Thanks Mark, Problem is I need something else in the photo to reference the bend off of. If I have to I will wait till the retreat and figure it out then. Thanks

Re: Need some help if possible.

Posted: Mon, Sep 17 2012, 05:54 PM
by cadguy
Mikey, here's a view of the indoor next to the 11" handle. The grid is 1" sqr. Hope this helps.
Rev handles.jpg
Rev handles.jpg (250.46 KiB) Viewed 1740 times

Re: Need some help if possible.

Posted: Mon, Sep 17 2012, 06:19 PM
by Darkspark
That is exactly what need! You are the Best! Thanks!

Re: Need some help if possible.

Posted: Mon, Sep 17 2012, 06:55 PM
by cadguy
thanks, just tell my wife that too!!
Looking forward to the retreat.